Chevrolet 2004 Blazer Manual do Proprietário descarregar pdf (Página 4)

BODY BUILDERS INSTRUCTIONS

The Incomplete Vehicle Document (IVD) is supplied with each incomplete vehicle, and provides information that should be used by

intermediate and final stage manufacturers in determining conformity to applicable Federal Motor Vehicle Safety Standards (FMVSS). The

IVD also includes information which must be followed in order to ensure that Environmental Protection Agency (EPA) and California

emissions certification requirements and NHTSA Fuel Regulations are met.

The Body Builders Manual contains information that may be used in addition to the IVD for any manufacturer making alterations to a GM

complete/incomplete vehicle. No alteration should be made to the incomplete vehicle which either directly or indirectly results in any

component, assembly or system being in nonconformance with any applicable Federal Motor Vehicle Safety Standard or Emission

Regulation. Intermediate and final stage manufacturers should be familiar with all Federal Motor Vehicle Safety Standards and Emission

Regulations and aware of their specific responsibilities as manufacturers.

For further assistance contact Upfitter Integration at: 1 (800) 875-4742, or go to our Web site at “http://www.gmupfitter.com.”

Section 0 — General Instructions

Check for proper clearance between body members and chassis components which may in any way affect the reliability and performance

of the vehicle by developing abrasion and wear points from moving parts or degradation from extreme environment or thermal exposure or

may increase interior noise.

Check headlamp aim and all vehicle illumination systems for proper operation when the vehicle has been completed. Re-aim headlamps

when necessary. Check for proper operation of windshield washer, wipers and defroster system.

Extreme care must be taken when working on vehicles equipped with Powertrain Control Module (PCM), Vehicle Control Module (VCM) or

any electronic unit associated with an inflatable restraint system. (See Owner’s Manual).

If arc-welding is employed on the chassis, precautions must be taken to protect all vehicle components, especially brake, fuel lines and fuel

tank assembly, electrical wiring and ECM/PCM/TCM or VCM. To avoid electronic component damage, disconnect battery (batteries);

disconnect the negative cable first, followed by the positive. To reconnect cables; connect the positive first, then the negative.

When welding components to the frame assembly, remove the wax coating in the area of the weld in order to obtain secure welds. After

completion of the weld, a compatible corrosion protection should be applied to the affected weld areas.

All labels on the vehicle (any message applied to the vehicle or vehicle component that informs, instructs, or warns) must appear on the

completed vehicle so the user can read them easily and without obstruction.

S/T SMALL UTILITY – SUV

(

HEVY BLAZER & GMC JIMMY

)

S/T Small Utility – SUV 2004

PAGE

(Section 0 — continued on next page)

1 2 3 4 5 6 7 8 9 ... 38 39

Sem comentários

Chevrolet 2004 Blazer Manual do Proprietário Página 4