Chevrolet TORRENT - NAVIGATION SYSTEM 2008 Manual do Utilizador Página 12

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 13
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 11
Warranty Information
GM is very concerned about customer safety and tire performance. Anytime a
customer brings a GM vehicle in for a tire or tire pressure monitoring concern, we
encourage our dealers to perform a complete check of tire conditions, pressures, and
the TPM system if necessary. Under normal circumstances, the condition of tires,
TPM reprogramming during tire rotation, road hazard repairs, and
checking/maintaining tire pressure are the responsibility of the vehicle owner. GM
Dealers should encourage customers to inspect/check and maintain their tires and
tire pressure on a regular monthly basis.
The tires and the tire pressure monitoring system are covered by the vehicle bumper
to bumper warranty for manufacturing defects. It is GM's responsibility to perform
repairs when a defect exists. If no defect exists, the customer should be responsible
for the tire/system check.
GM does not cover the normal inspection and maintenance of tires and tire pressure.
The use of this labor operation E0716 is intended to identify system defects and
verify proper operation.
Warranty Information (excluding Saab U.S. Models)
E0716 -- Diagnostic System Check - Tire Pressure Monitoring This labor operation
should be used to check proper TPM system operation when a customer brings their
vehicle into the dealership with a Service Tire Monitor System message/light (blinks
on startup, codes in system).
If a customer comments on a Check Tire Pressure / Low Tire Pressure message/light
(light was on steady - no flashing), the tires should simply be inflated to the proper
pressure - this is not a warrantable repair.
E0719 -- Washer, Lower Tire Pressure Warning Sensor Replacement This labor
operation should be used whenever the rubber grommet is replaced.
E0722 -- Tire Pressure Indicator Sensor Replacement This labor operation should
only be used when a System Malfunction has been confirmed (by labor operation
E0716) and the Diagnostic Trouble Code (DTC) corresponds to a Sensor Fault (DTCs
C0750, C0755, C0760 and C0765).
For vehicles repaired under warranty, use:
Vista de página 11
1 2 ... 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários